15162 Autoloader ALE: timeout moving bay <bay#> shutter cylinder Platesetter_3244 Check for mechanical interferance, Check alignment of shutter cylinder Hall effect sensors, and cabling. Resume, Open side panels and check that shutter is not obstructed. Call Creo service if problem persists. Bay shutter closed sensor was not detected within "shutter_delay" while closing, or bay shutter open sensor was not detected within "shutter_delay" while opening. If opening when this error occurs then the firmware will close it again, (set verbose 1 for message) ../nvs/al_cal_nss.xmlNVS: al nss ../nvs/aldly_cal_shut.xmlNVS: aldly shut ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:53 2008 PST http://techplanet.creo.com/output/computer_to_plate/platesetter_3244/content/troubleshooting/15162.htmlOther: Troubleshooting information